Contact us
Collection
Five points for attentionnew log log saws
2018-10-20 人阅读
Logs and multi saws manufacturers share the points for attention in using new log and multi saws.
One: idling, the first use, idling about 30 minutes, summer high temperature also need water idling, its intention is to further eliminate the impact of welding knife on the matrix, and strengthen the multi-blade saw blade in high-speed torsion state to adhere to the memory of the intrinsic quality.
Two: the material must not be less than 0. 5 mm 3, and place insurance, the bottom should be padded with square timber, stuffed solid solid, waste materials should be located in the symmetrical position of the desk, to ensure that the homework trolley and barren materials of the tranquillity, not shaking, trembling appearance.
3. Adjust the travel switch according to the length, width and height of the waste material, so that the lifting of the saw blades and the travel of the feeding vehicle are in a reliable and useful scale. The blade of the saw blade should be 10 to 20mm away from the block before sawing. After sawing, the sawblade should be 20-40 mm away from the bottom of the waste material. Before the saw blade runs left and right, the saw blade should be completely withdrawn from the waste material sawblade. The distance should not be less than 150-200 mm to avoid the saw blade hitting the waste material.
4. Trial cutting can be carried out after the multi-blade saw blade is idle and stable. It is forbidden to drive the multi-blade saw blade when the blade edge of the multi-blade saw blade is touched by the waste material. It is forbidden to stop the change of the saw blade in the cutting process, and it is necessary to withdraw from the saw blade to stop the rotation.
Five: When cutting, if it is found that many pieces of sawing wastes are unsteady, the cutting will be stopped immediately until the wastes are fixed and strong enough to sustain homework. Don't indulge in moving wastes during cutting.
One: idling, the first use, idling about 30 minutes, summer high temperature also need water idling, its intention is to further eliminate the impact of welding knife on the matrix, and strengthen the multi-blade saw blade in high-speed torsion state to adhere to the memory of the intrinsic quality.
Two: the material must not be less than 0. 5 mm 3, and place insurance, the bottom should be padded with square timber, stuffed solid solid, waste materials should be located in the symmetrical position of the desk, to ensure that the homework trolley and barren materials of the tranquillity, not shaking, trembling appearance.
3. Adjust the travel switch according to the length, width and height of the waste material, so that the lifting of the saw blades and the travel of the feeding vehicle are in a reliable and useful scale. The blade of the saw blade should be 10 to 20mm away from the block before sawing. After sawing, the sawblade should be 20-40 mm away from the bottom of the waste material. Before the saw blade runs left and right, the saw blade should be completely withdrawn from the waste material sawblade. The distance should not be less than 150-200 mm to avoid the saw blade hitting the waste material.
4. Trial cutting can be carried out after the multi-blade saw blade is idle and stable. It is forbidden to drive the multi-blade saw blade when the blade edge of the multi-blade saw blade is touched by the waste material. It is forbidden to stop the change of the saw blade in the cutting process, and it is necessary to withdraw from the saw blade to stop the rotation.
Five: When cutting, if it is found that many pieces of sawing wastes are unsteady, the cutting will be stopped immediately until the wastes are fixed and strong enough to sustain homework. Don't indulge in moving wastes during cutting.